angular positions造句
例句与造句
- angular position sensor
角度位置传感器 - error analysis on getting inertial angular position with linear accelerometers is improved
改进了对线加速度计测量惯性姿态角的误差分析。 - theory of getting inertial angular position from linear accelerometer measurements with double integration algorithm is analyzed
分析了使用线加速度计测量惯性角加速度,通过二次积分算法得到惯性姿态角的原理。 - the balancing process, then, involves determining the number of gram-centimeters to be compensated for, and locating the proper angular position at which to add such compensation
厘米）加在转子固有不平衡量的相反位置上，故平衡的过程涉及不平衡量大小的补偿值的决定，及补偿值的正确定位。 - disengage in unprecedented 2 to 4 msecs of an overload signal, compared to conventional couplings that take a full second to disengage . ours automatically re-engage at the precise angular position
接到过载信号后，2-4毫秒断开。并且以精确的角度自动重新连接。这个时间是无法比拟的。常规联轴器需要1秒时间。 - It's difficult to find angular positions in a sentence. 用angular positions造句挺难的
- to restore balance, that same number of gram-centimeters must be added to the assembly 180 degrees away . the balancing process, then, involves determining the number of gram-centimeters to be compensated for, and locating the proper angular position at which to add such compensation
恢复平衡需要将一定数量的不平衡量(克?厘米)加在转子固有不平衡量的相反位置上，故平衡的过程涉及不平衡量大小的补偿值的决定，及补偿值的正确定位。 - this paper puts emphasis on dynamic simulation based on switched reluctance drivers's ( srd's ) nonlinear model, and study of fuzzy control for srd . based on switched reluctance motor's linear, nonlinear model, the dynamic simulation model of srd's is built respectively . the phase current, phase torque, total torque and speed of srm in current chopping control ( ccc ) and angular position control ( apc ) are calculated respectively with this simulation
本文在分析sr电机线性、准线性、非线性模型的基础上建立了四相(8/6极)sr电机调速系统(srd)动态线性、非线性仿真模型，分别对电流斩波控制方式(ccc)与角度位置控制方式(apc)下sr电机相电流、一相转矩、合成转矩及角速度进行了仿真。 - two nonlinear simulation methods are designed by curve fitting method and anfis which seem simply and right in the simulation experiment . based on the model different control strategies also were realized in detail such as chopped current control ( ccc ), angular position control ( apc ), amplitude-change ccc and pi control . a simple torque sharing function ( tsf ) method and a tsf controller were designed which decreases torque ripple effectively
文章中还建立一种基于模糊神经网络的非线性模型,并对比分析了三种方法,仿真中确定了电机的最优开通关断角,在此基础上实现了电流斩波控制、角度位置控制、变幅值电流斩波控制以及分段双闭环pi控制,仿真结果表明,它实现了电机的正常运行,很好的抑止了电机转矩脉动,同时有效地降低了噪声。